Fall Protection Requirements For Bucket Trucks

Be sure proper personal fall protection is provided and used.

Fall protection requirements for bucket trucks.

Since most frame scaffolds are between 6 and 10 tall this allows users to not have to worry about fall protection every time they set up a single bay or. It applied an osha requirement not previously used for aerial lifts. In august 2011 osha issued an memorandum regarding fall protection on aerial lifts during construction activities. Since construction workers in bucket trucks scissor lifts and boom type elevating work platforms are on a horizontal surface a positioning device may not be used for those workers.

On bucket trucks osha requires a full body harness and lanyard or a restraining device to prevent falls. Do not climb on or lean over guardrails or handrails. It s as simple as that. According to subpart l of the construction regulations specifically 1926 451 g 1 fall protection on scaffolding is not required until you are greater than 10 off the lower level.

Stand firmly on the floor of the bucket or lift platform. However one specific regulation is broad and encompasses a wide range of applications and instances. Do not use planks ladders or other devices as a working position. Fall protection what is and what can it do for you.

Critical components are those in which a failure would result in a free fall or free rotation of the boom. Ensure that access gates or openings are closed. So why then. Fall protection for activities not in the construction industry is addressed in specific standards for the general industry shipyard employment marine terminals and longshoring industry this section highlights osha standards federal register notices rules and proposed rules preambles to final rules background to final rules directives instruction to osha staff letters of.

And it can save your life that s what it can do for you. To help keep workers inside guardrails osha allows restraining devices with a 2 ft. Several osha regulations can and do apply to fall protection for trailers and trucks. The provisions of the american national standards institute standard ansi a92 2 1969 section 4 9 bursting safety factor shall apply to all critical hydraulic and pneumatic components.

All fall protection plans must be prepared and approved by a qualified person and also re approved by a qualified person if anything in the protection plan changes. It is there to protect you in case of a fall. When working in aerial lift or boom type platforms including scissor lifts and bucket trucks the worker must either have a guardrail system in place where applicable or be tied off. It is this particular gotcha regulation where emphasis could be applied to trucks and trailers.

Use a body harness or a restraining belt with a lanyard attached to the boom or bucket.