Fix Sprinkler Pipe Under Sidewalk

Move the pipe and hose back and forth in the trench using a sawing motion.

Fix sprinkler pipe under sidewalk.

Repeat the process until the pipe clears the sidewalk. First find the leak by looking for escaping water or sprinkler heads with little to no flow. Do this every two inches or so. This article explains how to dig and run pipe under an obstacle such as a driveway or sidewalk.

The most efficient and cost effective way to bore under an obstacle is to create a hole using the power of water. Now using a pvc pipe cutter cut the piece of schedule 40 pvc pipe about two to four feet longer than the width of your sidewalk or driveway. Grasp the pipe and the garden hose at the end farthest away from the sidewalk. In the past it was required to bring out the jackhammers to break through your driveway in order to get access to a pipe located underneath your driveway.

Protect the end of the pipe with a block of wood to prevent cracking it with the sledge hammer. Under driveway pipe repair without digging excavation. Dig up the dirt above the bad pipe with a shovel you will probably also need a hand trowel to dig up the dirt under the pipe. A damaged sprinkler line that sits under concrete should be repaired right away because a leaky supply line can lead to severe problems with the sprinkler system.

You will want to have at least 6 inches 15 2 cm on each side of the break clear and enough room for you fist underneath the pipe. Grab a sledgehammer or mallet and a block of wood to drive the chiseled end of pvc pipe cut through the soil. We now offer a much better solution. The concentrated blast of water coming.

Then dig up and expose the damaged pipe so you can remove it. Use a slip coupling to replace the damaged section of pipe fill in the dirt around it and you re done. Slide the pressure washing wand into the pipe and start to tap the pipe under the sidewalk as the water cuts the channel. If your pipe has sprung a leak you must remove the damaged section of pipe and replace it was a new one.

First dig your trenches on either side of the walk to the depth of the rest of your sprinkler system usually about 6 12 inches minimum. As you remove mud and rocks tap the end of the pipe with a sledge hammer to drive the pipe.